RC Logger RC EYE One Instructions d'exploitation télécharger pdf (Page 37)

2. For reference, put the “RC EYE One S” onto your work surface with the model LED (see arrow) pointing

to the front right.

3. The front motors (motor 1 and 2) are at the “front” for this model and must have red propellers. Motor 1

turns counter clockwise, motor 2 turns clockwise.

4. The rear motors (motor 3 and 4) must have black propellers. Motor 3 turns clockwise, motor 4 turns

counter clockwise.

5. Do not bend the motor shafts. Bent motor shafts (e.g. from crashes) inuence the ight properties

negatively due to the vibration that results and the irritation to the sensors. Motors with bent motor shaft

must be replaced.

Replacing a motor

1. Remove the defective motor by removing the screw from the motor boom. Pull the motor holder from the

boom. Make sure to use a proper precision screwdriver. Do not damage the screw-head!

2. Unplug the motor cable from the motor.

3. Replace the defective motor and re-install the motor into the boom. Secure back the xing screw. Do not

tighten the screw too much as you may damage the motor mount.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 287 288

Pas de commentaire

RC Logger RC EYE One Instructions d'exploitation Page 37